Bosch Nexxt washer Operating, Care And Installation Instructions Manual page 24

Spin speed
The maximum spin speed can be
reduced.
The maximum spin speed depends
on the setected program: see also
information on Page 19.
Turn the program seiector to
the desired program.
Load the taundry and close the
door.
The Start/Pause indicator tight
flashes (red).
Example:
Press the Menu button until
"Spin speed" is dispIayed.
Current spin speed flashes.
The Start/Pause indicator tight
flashes (red).
[_lf no buttons are pushed within
10 seconds the display will
revert back to normat "Ready".
Changed settings will be
retained.
Press the Select button until
the desired spin speed or "No
final spin" is displayed.
You can select other settings by
pressing the Menu button and
change them by pressing the
Select button.
Press the Start/Pause button.
The program starts.
The indicator tight is tit red.
[_The individual program steps
are indicated in the display field.
Program finished at
[_To change the program end
time the clock must be set first
(see Page 27).
Turn the program selector to
the desired program.
Load the taundry and close the
door.
The Start/Pause indicator light
flashes (red).
Example:
Press the Menu button until,
"Program finished at" is
displayed.
Current end time flashes.
The Start/Pause indicator light
flashes (red).
If no buttons are pushed within
10 seconds the display wilt
revert back to normal "Ready".
Changed settings will be
retained.
i_i_ _ _
E]
E]
E]
Press the Select button until
the program end time is dis
played. The program end time
can be set in 30 minute steps.
The end time can be pro
grammed up to a maximum
24 hours in advance.
The end time will be reset if the
program, additional options or
the current time is changed.
If there is a small toad of lightly
soiled laundry, the program
may end well before the se
tected end time,
If there is a large load of heavily
soiled laundry, the program
may end several minutes after
the selected end time,
You can select other settings by
pressing the Menu button and
change them by pressing the
Select button.
= IVtenu Seiec|
Press the Start/Pause button.
The delayed Start is activated.
The indicator light is lit.
"Time delay" is indicated in the
display field.
To save energy, all displays are
switched off 30 seconds after
the buttons were last pressed.
If the Select button is pressed,
the displays are switched on
again.
24