Bosch Nexxt washer Operating, Care And Installation Instructions Manual page 33

Fault
Control lights do not light
up.
Program does not start.
Start/Pause indicator
light flashes.
Program does not start.
"Check Door !" indicated
in the display field.
"Pressstart" is indicated
in the display field.
Program does not start.
"RealTime delay" is
indicated in the display
field.
Clock cannot be set.
"Set clock:" text remains
in the display field even
though the Menu button
has been pressed.
No time displayed.
End time cannot be
selected.
Spin speed cannot be
selected.
Child lock cannot be
selected.
Detergent residue in the
detergent dispenser.
Water does not enter the
machine or detergent is
not washed away.
"Watertap closed?"
indicated in the display
field.
Water cannot be seen in
drum.
Possible cause
A fuse has blown.
Powerfailure.
Appliance is in energy-savingmode.
This is not a fault.
Start/Pause button not pressed.
Door not closed properly.
End time selected but still not activated by pressing
the Start/Pause" button.
End time selected and activated.
Program has already started; when a program has
started, the clock cannot be set.
The setting has switched from hours to minutes; both
selection points have the same text.
Time not set.
Time not set.
Program has already started; when a program has
started, the end time can no longer be selected.
Spinning is already in progress; during spin cycle the
speed cannot be changed.
Programselector is set to Drain; spin cycle is not
possible with this program.
The program has already started.
Detergentwas damp or lumpy.
Water tap not turned on.
Action
Replacethe fuse of the individual circuit.
Call Customer Service if this fault recurs.
An interrupted program will be resumed when power
is restored. If the laundry is to be removed during a
power failure, call Customer Service
(refer to Page 35).
Press the Select button; energy-savingmode is
terminated.
Press the StartJPause button.
Check whether laundry is trapped in door.
Close the door (a click should be heard).
Program continues.
Press the Start/Pause button.
None. Appliance starts automatically.
Wait until program ends.
None.
Set time; see Page 27.
Set time; see Page 27.
Before starting the program, select and start the
desired end time; see Page 24.
Select speed before spinning.
tf required, select another program.
Child lock can be selected in pause mode.
Supplyhose kinked or pinched.
Strainers in supply hose clogged.
Water pressure too tow.
This is not a fault.
The water level is belowthe visibIepart of the drum.
Clean and dry the detergent dispenser; see Page 30.
Use the cap of the detergent boWeto measure liquid
detergents.
Turn on water tap.
Program continues.
Eliminate the cause.
Cleanthe water inlet strainers; see Page 30.
Eliminate the cause.
33