Advertisement
Available languages
Available languages
Z_ CAUTION: Prior to moving the unit,
always disconnect the garden hose via
the garden hose connector.
Z_
CAUTION:
Always
store
your
pressure washer in a location
where
the temperature will not fall below 40° F
(4° C). The pump in this machine
is
susceptible
to permanent
damage
if
frozen.
FREEZE
DAMAGE
IS NOT
COVERED BY THE WARRANTY.
END OF USE AND WINTER
STORAGE INSTRUCTIONS
1.
When finished using the pressure
washer, you must first drain and
rinse the detergent tank.
2.
Run the pressure washer in low
pressure until all of the soap
is
drained from the detergent tank.
3.
Pour clear water into the tank and
run it through on low pressure as
though it were detergent.
NOTICE: Failure to clean properly will
cause bottle or suction tube to become
clogged and inoperable.
4.
Turn the machine OFF and squeeze
the trigger to release the trapped
pressure inside of the machine.
5.
Remove both the garden hose and
high pressure hose from the unit.
6.
Disconnect the lance from the gun.
7.
Turn ON the machine and allow it
to run for 5 seconds. (This will clear
out most of the water trapped in
the pump).
8.
Unplug machine.
9.
Wrap
high
pressure
hose
and
power supply
cord onto storage
rack and snap power supply cord
into place as shown.
10. Store the machine and accessories
in
a
dry,
climate
controlled
environment.
Do not
store
the
machine or accessories
in a place
where the temperature could drop
below 40 ° F (4 ° C).
z_ DANGER: Risk of fluid injection.
When using
replacement
lances or
guns with this pressure washer,
DO
NOT use a lance and/or
lance/gun
combination
that is shorter
in length
than
what
was
provided
with
this
pressure
washer
as measured
from
the nozzle
end of the lance to the
gun trigger.
NOTICE:
The
use
of
any
other
accessory
not recommended
for use
with
this
tool could
be hazardous.
Use
only
accessories
rated
equal
to or greater
than the rating
of the
pressure washer.
14- ENG
Advertisement
