Advertisement
Available languages
Available languages
31. Never defeat thesafety f eatures of
thisproduct.
32. Do not operatemachine with
missing, broken or unauthorized
parts.
33. Neversprayflammable liquids
or usepressure w asher i n areas
containingcombustibledust,
liquid, orvapors.
/!X WARNING:
Risk
of injection
or
injury. Do not direct discharge stream
at persons.
SAVE THESE
iNSTRUCTiONS
SAFETY FEATURES
AUTOMATIC
TOTAL STOF _
The pressure washer is equipped with
a stop device which will sense when
the trigger on the gun is released. It will
open the power circuit to the motor and
cause the pressure washer to stop.
Z_ WARNING:
If Automatic
Total Stop
fails to operate,
DO NOT USE THE
MACHINE.
Contact
our
customer
service
department.
Further use will
damage
the machine
and/or
cause
personal injury.
Z_ WARNING:
The pressure washer
is also equipped
with a main power
ON/OFF switch located on the unit. It
should
always be moved to the OFF
position when the pressure washer is
not being
used to prevent
possible
injury or damage.
MOTOR OVERLOAD
The electric motor inthis pressure washer
is equipped with an overload protection
device which will automatically
shut off
the motor in the event the motor draws
excessive
current
or overheats.
The
device will automatically reset itself and
resume normal operation after a short
period of time.
GROUND-FAULT
CIRCUIT
INTERRUPTER
PROTECTION
This pressure washer is provided with a
Ground-Fault
Circuitqnterrupter
(GFC0
built into the plug of the power supply
cord. This device provides
additional
protection
from
the risk
of electric
shock. Should replacement of the plug
or cord become
necessary, use only
identical replacement parts that include
GFCI protection.
SERVICING A DOUBLE INSULATED
APPLIANCE
ln a double-insulated
product,
two systems of insulation are
provided instead of grounding.
No
grounding
means
is
provided on a double-insulated
product,
nor should a means for grounding
be
added to the pressure washer.
Servicing
a double-insulated
product
requires extreme care and knowledge
of the system, and should be done only
by qualified service personnel.
Replacement
parts
for
a
double-
insulated product must be identical to
the parts they replace.
A double-insulated
product is marked
with the words "DOUBLE-INSULATION"
or "DOUBLE-INSULATED".
The symbol
above may also be marked
on the
product.
POWER SUPPLY AND
ELECTRICAL
INFO
GROUND-FAULT
CIRCUIT
INTERRUPTER
PROTECTION
The
pressure
washer
is
factory-
equipped with an electrical cord and a
Ground Fault Circuit interrupter (GFCI)
power
plug.
This
cord
should
only
be connected
to an electrical
outlet
installed in accordance with local safety
regulations.
NOTE:
The power
supply
must
be
120 V, 60 Hz and a minimum 15 amp
dedicated circuit.
6- ENG
Advertisement
