Black & Decker 11BLE-325 Instruction Manual page 20

Connecting and
Disconnecting
the Spray Lance
NOTE: Due
to the high
i pressures
i produced by
your pressure
washer, the
lance must
seal tightly to
the gun. As
the result of
normal operation
the lance can
i become difficult
ito attach or
iremove and
this process
may require
considerable
force.
To attach the Lance - apply steady downward
3ressure on the lance (In the direction of the
trigger) while simultaneously twisting the
lance 90 ° counterclockwise. It may help if
you set the gun vertically on a flat surface
with the lance pointing upwards. The two
tabs on the end of the lance must be fully
inserted in the gun before the lance will twist
and lock. If this does not work then remove
the bayonet o-ring from the end of the lance
and attach the lance to the gun without the
o-ring in place. If the lance attaches to the
gun without the o-ring in place you will need
to replace the o-ring. Please contact our
customer service department at www.power-
washer.us or by calling 1-800-381-0999.
To remove the Lance - release any trapped
3ressure in the gun / hose by turning the unit
OFF and squeezing the gun trigger. Apply
steady downward pressure on the lance (In the
direction of the trigger) while simultaneously
twisting the lance 90 ° clockwise. It may help
if you set the gun vertically on a flat surface
with the lance pointing upwards.
20- ENG