Maintenance And Troubleshooting; Caring For Your Tv; Extended Absence; Tvpictureinterference - Zenith Sentry 2 Operating Manual & Warranty

MAINTENANCE AND TROUBLESHOOTING
CARING FOR YOUR TV
Your TV will look better, have a longer life and perform
better if you care for it properly.
First check to see that the TV is off. For added
safety, unplug the TV from the power outlet.
Picture Glass Cleaning
The picture tube face attracts dust particles and should be
cleaned regularly. To clean the face, spray a small amount
of glass cleaner on a cleaning cloth and wipe the picture
tube glass face until dean. Repeat if necessary.
To delay new dust accumulation, wet a soft cloth in
lukewarm water in which a little fabric softener or Ivory
dishwashing detergent has been mixed. Wring the cloth al-
most dry. Wipe the glass face. Make sure no drops of mois-
ture are squeezed onto the glass. Do not wipe the glass dry.
Allow the glass to air-dry before you turn the TV on again.
Cabinet Care
Non-Wood Cabinet or Cabinet Components.
Moisten a soft cloth with a mild soap solution or Ivory dish-
washing detergent. Wipe the surface with a damp cloth.
Then rinse the cloth in clean water and wipe the surface
again. Allow the TV to air-dry before turning it on.
Wood Cabinets or Cabinet Components.
Use any good furniture cleaner and polish. Regular care
will help preserve the finish.
EXTENDED ABSENCE
Before an extended absence (such as a vacation) you may
want to unplug the power cord from the electrical wall out-
let. This will protect the TV from possible damage from
lightning or power line surges. If you have an outdoor anten-
na, you may also want to disconnect the antenna lead-in
wires on the back of the TV.
NOTE: If you unplug your TV, you will have to reset the
clock to the current time.
TVPICTUREINTERFERENCE
Your TV picture may be affected by interference caused by
one or a number of factors. These include:
Nearby Automobile Ignition, Electrical Appliances,
etc.
Which causes a speckled, streaked picture. This is most
noticeable in weak signal areas.
Snow in Picture Caused by insufficient signal. Usually
caused by the TV being located too far from the TV station
or by an improper antenna installation.
Ghosts or Reflections Caused by signals being reflected
from surrounding buildings, water tanks, or other high struc-
tures.
Radio Signal Police, amateur or CB radio transmitters may
cause interference.
These interference problems can often be corrected
through the use of a better antenna, signal amplifiers, or
various filter devices. See your TV dealer for additional in-
formation, and available TV accessories.
C10CAR_I 11 -- 1