Zenith INTEQ IQ5270 Operation Manual & Warranty page 91

H/hat you should do when you get a
new VCR
NOTE: THIS PROCEDURE REQUIRES THE USE
OF THE UNIVERSAL REMOTE.
Make sure your Remote Emitter is positioned 2-3 inches in
front of your new VCR. Find the code(s) for your brand of
new VCR on tlhe "VCR Code" chart and write the code(s)
here.
l, Press TO DO until you see the StarSight Setup menu.
2.
Press the .t. to highlight "Change VCR."
cs:L
5:02P
_. Press STAR and follow the on-screen instructions.
I
YOU SHOULD ALSO KNOW...
•
It is important that your equipment works properly
during each test. For example, make sure your VCR
turns on. If the equipment does not respond, you
need to try another VCR code and test your VCR
again.
• Remember to reprogram your remote so it can
operate your new VCR. See the section on
"Universal Remote Control" in the TV portion of
this guide.
• If you have tried all the codes and need assistance,
call the StarSight Help Desk at (800) 628-STAR.
i_iiiN!iNiiiiiii!!!!!!iiiiiiiiiiiiiiiiiiiiii!i!!iiiiiiii CBL 5 : 02P
What
changes are you
making
:
t!O you
r VCR_;
ReplaCe VCR
R e m o v e V C R .....
Enter;your selection here:
.... To continue, press ENTER.
To exit, press QUIT.
:o6-:_*_o D- 1