Table of Contents
Advertisement
STANDARD
CONNECTIONS
FOR YOUR TV
SETUP
4:
"IV WITH
VCR AND
CABLE
BOX
If you receive your television signal through your VCR, connect
your television as shown here.
_k
DO NOT UNPLUG YOUR CABLE
BOX AT ANY TIME!
DO NOT PLUG YOUR TV INTO THE
BACK OF YOUR CABLE BOX!
_A
1. Turn off, but do not unplug,
your Cable Box.
2. Attach the cable coming out of the wall O to
the "ANT/CABLE
2" jack on the back of
your TV.
3. Attach an RF cable O between your TV's
"LOOP OUT TO DECODER"
jack, and the
Cable Box's "Input"
or "Cable In" jack.
4, Attach an RF cable _ between your Cable
Box's "Output"
or "TV Set" jack, and the
VCR's "VHF In" (From Antenna)
jack of
your VCR.
5. Attach an RF cable Obetween
your VCR's
"VHF Out" (To TV) jack, and the "ANT/
CABLE
1" jack on the back of your TV.
6. Take the Remote Emitter cable _ and plug the jack
into the "StarSight
Control
Port" on the back of the
TV. Route one Remote Emitter
wire under the
VCR and place its plastic bulb about two
inches in front of the VCR's front panel O, as
shown in the illustration.
Make sure that the plastic
bulb is facing the front panel.
Do the same for the
Cable Box _. Do not adhere the Remote
Emitters
until after you have completed
activating
StarSight
and you have confirmed
the correct
codes that operate your equipment.
Once the
codes are confirmed,
peel off the backing
of the
sticker on the Emitters
and adhere it in place.
NOTE,:
The Remote Emitter is only necessary if you are planning to
activate StarSight and want StarSight to control the record
functions of your VCR and the channel tuning of your cable
box.
Cable Box and VCR Connection
7. Locate
the area
of the TV's
jack
panel
that is labeled
"Video
! In."
A_tach
the three
Audio/Video
(A/V)
cables
I_ to the "Video,"
"Audio
R" and "Audio
L"
jacks
and attach
the other
ends of the cables
to the
corresponding
"Video
Out,"
"A_adio R Out"
and
"Audic
L Out" jacks
on the bac_
of your VCR.
Connecting
these
A/V cables
is necessary
if ...
rq You have a VCR without
a front panel channel indica-
tor chat uses an on-screen
display.
I:1 Yon have a stereo VCR and would like to take advan-
tage of the stereo feature.
U You would like to take advantage
of the TV's PIP
feature.
8. Plug your TV into a power
outlet
that is not
controifled
by a light
switch.
9.
If you want
to activate
StarSight,
proceed
to "Step
1. Fill out the StarSight
Checklist"
in the StarSight
section
of the operating
guide.
_95o-o
1 -- 4
Advertisement
Table of Contents
