Table of Contents
Advertisement
REMOTE
CONTROL
Z-TRAK
PROGRAMMING
YOUR
Z-TRAK
REMOTE
Your Z-Trak remote is already programmed
to work with most
Zenith VCR's.
If you have a non-Zenith
VCR, or if your Zenith
VCR does not respond
to your Z-Trak remote, you will need to
program
your remote as follows:
1.
Rel!er to the table
of VCR
Codes,
in this section
of
the guide.
Locate
the 3-digit
number
which
corre-
sponds
to your brand
of VCR.
2,
Make
sure your TV is turned
on.
3.
While
pointing
the Z-Trak
remote
towards
your
Zeaith
TV, simultaneously
hold
the MUTE
and
ENTER
keys
until the TV displays
a VCR
"Setup"
screen
(about
three
seconds).
The VCR
key will also
light
upon entering
the Programming
mode.
4,
Notice
that the current
VCR
brand
code
(initially
"201")
is displayed
on the TV screen.
Roll the track-
ball
up or down
(or use CHAN
Up/Down)
to choose
the 3-digit
number
of your
VCR.
5.
When
the correct
3-digit
number
is displayed
on the
TV screen,
use the POWER
key to make
sure that
your
VCR
turns
on and off properly.
If it does not
respond,
refer
to the VCR
Codes
table
to select
a
different
3-digit
number.
6.
If your VCR
turns
on and off successfully,
press
the
trackball
(or ENTER)
to save the current
VCR brand
code.
The
setup
screen
will disappear
from
the TV.
Also,
the VCR
key will flash
3 times
upon exiting
the Programming
mode.
The remote
will be in the
VCR
mode.
7.
Now try other
controls
on your
VCR,
such as Play,
Rewind,
etc.,
to make
sure that
the correct
VCR
brand
code
numher
was selecl:ed.
(If not, repeat
steps
3 to 7.)
8.
The MUTE
key can be pressed
at any time
to cancel
Programming
mode.
The original
VCR
brand
code
will remain
unchanged.
NOTE:
Only the VCR
mode
can be programmed.
9.
The Z-Trak
remote
will exit Programming
mode
automatically
after 60 seconds
if no key press
or
lrackball
movement
is detected
AUTO
FIND
OPTION
If you have tried all 3-digit codes listed for your VCR manufac-
turer, and none of them operate your VCR, you will need to try
"AutoFind" to see if a different code will operate your VCR:
1. Make sure your VCR is turned on.
2. Simultaneously
hold the MUTE and ENTER keys
until the VCR key lights up (about three seconds).
jjjl
r
[
I
IV displays
VCR code
Z-Trak Remote
Control
J
I
Equipment
to be
controlled
2o6-295o-o
1 1 -- 3
Advertisement
Table of Contents
