Brother MFC-9130CW Basic User's Manual page 121

Error Message
Registration
failed.
Rename the File
Replace Belt
1
Replace DrumX
1
(X ) shows drum unit
color that must be
replaced. BK=Black,
C=Cyan,
M=Magenta,
Y=Yellow.
Replace Fuser
Replace PF kit
Cause
Registration failed.
There is already a file on the
USB Flash memory drive with
the same name as the file you
are trying to save.
It is time to replace the belt
unit.
It is time to replace the drum
unit.
The drum unit counter was not
reset when a new drum was
installed.
It is time to replace the fuser
unit.
It is time to replace the paper
feeding kit.
Action
Press OK and try again.

Press and hold down
machine.
Wait a few seconds, then turn it on again.
Perform the auto color registration using
the Touchscreen (see Advanced User's
Guide: Auto Registration).

Put in a new belt unit (see Replacing the
belt unit on page 91).

If the problem continues, call Brother
Customer Service.
Change the file name of the file on the USB
Flash memory drive or the file you are trying to
save.
Replace the belt unit (see Replacing the belt
unit on page 91).
Replace the drum unit for the color indicated on
the Touchscreen (see Replacing the drum
units on page 86).
Reset the drum unit counter. (see Replacing
the drum units on page 86).
Call Brother Customer Service or a Brother
Authorized Service Center to replace the fuser
unit.
To replace Fuser Unit call Brother Customer
Service at:
1-877-BROTHER (1-877-276-8437) (in USA)
1-877-BROTHER (in Canada)
or to locate a Brother Authorized Service
Center, visit us at:
http://www.brother-usa.com/service/
Call Brother Customer Service or a Brother
Authorized Service Center to replace the
PF Kit.
To replace PF Kit call Brother Customer
Service at:
1-877-BROTHER (1-877-276-8437) (in USA)
1-877-BROTHER (in Canada)
or to locate a Brother Authorized Service
Center, visit us at:
http://www.brother-usa.com/service/
Troubleshooting
to turn off the
107
B