Advertisement
Unhook the antenna from your previous TV or
VCR and connect it to the back of the
Combination VCR as shown in the diagram.
If
your antenna system has separate UHF and
/ VHF lead-ins, you need a UHF/VHF Band Mixer
not supplied).
Back of Combination VCR
from
or
Antenna
__
300-75 ohm
Transformer
(not supplied)
o _ illii!!!{ii
!!!!!!!!i!!!!!!_
(A) Without a Converter/Descrambler
Box
With this connection, you can use your
Combination VCR remote control to select
channels for viewing and select unscrambled
channels for timer recording. Scrambled
channels may not be viewed or recorded with
this connection.
(B) With a Converter/Descrambler
Box
With this connection, you may record and view
any channel including scrambled channels.
Please note, however that channel selection
must be made at the cable company converter
box. Timer recording is limited to one channel at
a time, and you can only view the channel you
are recording.
(A)
from
CATV
(cable)
(B)
from
CATV
(cable)
Back of
Combination VCR
Cable TV
Converter Box
To Watch
and
Record
Scrambled/Unscrambled
Channels
Set the Combination VCR channel selector
to the output channel of the cable converter
box (e.g. CH3).
Now, select channels to be viewed or
recorded at the cable converter box.
FCC WARNING:
Any unauthorized
changes or
modifications to this equipment would void the user's
authority to operate.
Note to CATV System Installer
This reminder is provided to call the CATV (Cable TV)
System Installers attention to Article 820-40 of the NEC
that provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be
connected to the grounding system of the building, as
close to the point of cable entry as practical.
5
Advertisement
