Advertisement
Check the following points once again if you are having some
trouble with your Combination
VCR.
No power..
No pictutu u_buul_d..
Poor picture with normal suuJ_d...
Poor sound with normal picture...
Poor TV reception...
No color or poor color...
Ghosts (Multiple images)...
TV programs can't be watched...
TV program
uallt
be ruculded..
Timer recording can't be performed..
There's no playback picture or the playback pJctul_ AsnuLsy
or contains streaks...
Combination
VCH can't be letnote
uul_trolled...
• Check that the Power Plug Lscul_,pleteiy cutH_ucted to
an AC outlet.
• Check that the POWER button is set to on.
• Make sure your antenna or cable system ts connected to
the Combination VCR. (P.5)
• Check that the power plug is completely connected to an
AC outlet.
• Check that the POWER button is set to on.
• Adjust the BRIGHT, SHARPNESS,
and PICTURE
controls in the SET UP TV menu. (P.10)
• Adjust the VOLUME control.
(P.IO)
* Adjust the SHARPNESS
and PICTURE controls in the
SET UP TV menu. (P.IO)
• Adjust the TINT and COLOR controls in the SET UP TV
menu. (P.IO)
• Install a directional antenna.
• Make sure that the channel being received is in the
Combination VCRs memory.
(P.6)
Make sure your antenna or cable system is cu_r_ecLud to
the Combination VCR. (P.5)
Make sure that the record tab on the back of the
cassette is still intact. (P.5)
Set the recording start!stop time correctly.
(P.16-17)
Timer recording may not be performed or continued if a
power interruption of more than 1 minute occurs before
or during Timer Recording, even if power resumes
thereafter.
Adjust the TRACKING control slowly in either direction.
(P.13)
• Aim the Remote Contrul directly aL the ,emute sul_sul ell
the Combination VCR. (Refer to Control Reference Guide.)
• Avoid all obstacles which may interfere with the signal path.
• Inspect or replace the batteries. (P.2)
Video
cassette
can't
be insetted...
Video cassette can't be removed...
Eject does not function or insertion ca,u_ut be done.
Video cassette ejects when the REC and PLAY buttons are
pressed or when the two minutes before the Timer
Recording starts...
In the stop mode, the motor (CYLINDER) continues to
rotate...
• Insert the cassette with the window side up and the
record tab facing you.
• Check that the power plug is completely connected to an
AC outlet.
• Turn the POWER off and then on, and try ejecting or
inserting the tape again.
• Make sure the record tab on the back of the cassette is
still intact. (P.5)
• To enable the quick play mechanism, the cylinder will
rotate for about 5 minutes.
• The quick play mechanism reduces response time from
Stop to Play mode and from Play to Rewind search mode.
25
Advertisement
