Cleaning The Printer - Epson Stylus 3800 Printer Manual

100 | Maintaining and Transporting the Printer
WARNING: Be careful not
to touch the gears inside the
printer.
Caution: To avoid
damaging the
components as well as
the case, never use
alcohol or thinners to
clean the printer.
Be careful not to get
water on the printer
mechanism or on-screen
components.
Don't use a hard or
abrasive brush.
Do not touch the ink
absorption pads;
otherwise, printouts may
be soiled.
Don't spray the inside
of the printer with
lubricants; unsuitable
oils can damage the
mechanism. Contact
Epson if you think the
printer needs lubrication.

Cleaning the Printer

To keep your printer working at its best, you should clean it several times a
year.
1. Make sure the printer is turned off, then unplug the power cord and
disconnect the printer from your system. Let the printer sit for a minute.
2. If the outer case is dirty, clean it with a soft, clean cloth dampened with
mild detergent. Keep the ink cartridge compartment closed to prevent
water from getting inside.
3. If the front manual tray is extended, close it by pushing it in.
4. Open the top cover and then use a soft, lint-free cloth to carefully
remove any dust or dirt inside the printer. If the back of a printout is
soiled, carefully clean the plastic ribs using a soft, lint-free cloth wiping
in the direction of the arrows.
If the problem still occurs, clean the area using a soft, lint-free,
dampened cloth. Then wipe the inside of the printer dry with a dry,
lint-free, soft cloth.
5-100
Plastic
ribs