Gutter; Creating A Gutter; Staple - Kyocera TASKalfa 300i User Manual

Gutter

Creating a Gutter

1
2
3
4
5

Staple

KX DRIVER
Note that a change to one custom Finishing edge setting adjusts other
selections to make them compatible with the change.
A gutter creates additional blank space on the left side and at the top of the
sheet. It is often used for binding or stapling to make a print job easier to read.
Increasing the measurements in Gutter increases the margins around your text
and graphics on the left side, or top of the printed sheet. This creates a larger
margin space by shifting the printable area to the right, or down as much as one
inch (25.4 mm).
To create a page gutter, follow these steps.
In the Finishing tab, click Gutter.
In the Gutter width options, type a value between .20 to 1.00 inches (5.0 to
25.4 mm).
Long edge (left)
This selection modifies the outside margin on the left-side of the page.
Short edge (top)
This selection modifies the outside margin on the top-edge of the page.
Note: Availability of Gutter settings vary depending on Finishing edge
settings, and Orientation and Duplex mode settings in the Basic tab.
If text extends too close to the edge of the page, select Reduce image to fit.
The text appears slightly reduced and away from the edge of the page. If text
does not extend beyond the page when the gutter increases, clear Reduce
image to fit.
Click OK to return to the Print dialog box.
Click OK to begin printing.
The Staple feature is available on printing systems with a finishing device
installed.
After installation, the finishing device must be selected in the printer driver in the
Device Settings tab.
Note: Staple and Separation features cannot be used together.
If Printer default is selected as the Destination in the Basic tab, the selection
of an option in the Finishing tab results in the automatic selection of a
destination compatible with that finishing option. The destination is
automatically updated to the first available output tray that supports the selected
finishing option.
Finishing
6-3