Viewing Status Information - Epson pro4880gd Printer Manual

98 | Maintaining and Transporting the Printer
Note: You can replace
the ink cartridges, cutter
blade, and maintenance
tank yourself. Other
printer parts need to
be replaced by an
authorized Epson service
technician.
Note: Some status
information is a
projection based on the
last print made.
Follow these steps to print the status check sheet:
1. Make sure paper is loaded in the tray.
2. Press the
Menu
3. Press the button so you see
see
NOZZLE CHECK
4. Press so you see
.
PRINT
5. Press again to start printing.
Menu
The amount of ink left or the component life is indicated as follows:
= 100–81% ink or service life remaining
E*****F
= 80–61%
E**** F
= 60–41%
E*** F
= 40–21%
E** F
= 20–11%
E* F
= less than 10% ink or service life remaining
%

Viewing Status Information

To view printer status information instead of printing it, follow these steps:
1. Press the
Menu
2. Press the button until you see
. You see
Menu
3. Do one of the following:
To check the firmware version, press
•
press the button.
To check the number of pages that can be printed with each ink
•
cartridge, press
. When done, press the
This option must be enabled by using the maintenance mode on the
printer's control panel. See page 113 for instructions.
button. You see
PRINTER SETUP
TEST PRINT
.
, then press
STATUS CHECK
button. You see
PRINTER SETUP
PRINTER STATUS
.
VERSION
until you see
PRINTABLE PG
button.
98
.
, then press
Menu
. You see
Menu
.
, then press
again. When done,
Menu
, then press Menu
. You