Epson pro4880gd Printer Manual page 120

120 | Maintaining and Transporting the Printer
Caution: To avoid spilling
ink and damaging the
printer, you must leave
the cartridges in place,
raise the ink levers, and
lock the print head.
3. Raise the ink levers.
4. If you are using the 110 ml ink cartridges, leave them installed. If you
are using 220 ml cartridges, remove them and install 110 ml cartridges.
To store partially used cartridges removed from the printer, tape over
the needle valve hole and place each cartridge in a separate, resealable
plastic bag. Be sure to remove the tape before reinstalling the cartridges.
The printer must be powered on when removing or installing ink
cartridges.
5. Make sure the print head is in the home (far right) position. Then lock
the print head by pushing the green tab to the right.
6. If you saved the carriage retainer bracket, replace it and screw it back
into place. (See your Start Here sheet.)
120