Connect the management station or workstation to the switch
You can manage the switch using the Simple SAN Connection Manager, QuickTools, Enterprise Fabric
Management Suite, or the CLI. Simple SAN Connection Manager requires at least one FC connection and
an Ethernet connection to the switch. QuickTools and Enterprise Fabric Management Suite require an
Ethernet connection to the switch. The CLI can use an Ethernet connection or a serial connection.
•
If this switch is part of the 8Gb Simple SAN Connectivity Kit installation:
a. Connect at least one FC cable from the management station to the switch, or to another switch in
the same fabric.
b. Use a 10/100 Base-T straight cable to connect the switch Ethernet port to the LAN that connects
your management station that will run Simple SAN Connection Manager (see Indirect Ethernet in
Figure
19).
•
If this switch is a standalone installation and you plan to use QuickTools, Enterprise Fabric
Management Suite, or the CLI, connect the switch Ethernet port to the workstation, in one of the
following ways:
• Indirect Ethernet connection from the workstation to the switch RJ-45 Ethernet connector through an
Ethernet switch or a hub. This requires a 10/100 Base-T straight cable
• Direct Ethernet connection from the workstation to the switch RJ-45 Ethernet connector. This requires
a 10/100 Base-T cross-over cable
• Serial port connection from the workstation to the switch RS-232 serial port connector. This requires
a null modem F/F DB9 cable
1
1
Indirect Ethernet RJ-45 connection
3
Serial RS-232 connection
Figure 19
Management station and workstation cable connections
Configure the switch
You can configure the switch using Simple SAN Connection Manager, QuickTools, Enterprise Fabric
Management Suite, or the CLI.
Simple SAN Connection Manager switch configuration
For information about installing the Simple SAN Connection Manager application, see the HP
StorageWorks 8Gb Simple SAN Connection Kit Quick Start Instructions. The Simple SAN Connection
Manager software will prompt you to set the switch IP address, administrator password, and default zoning
when you first start that application.
When the configuration is complete, proceed to
(Figure
19).
(Figure
19). This connection supports the CLI only.
2
"Cable devices to the
HP StorageWorks SN6000 Fibre Channel Switch Installation and Reference Guide
3
2
Direct Ethernet RJ-45 connection
switch" (page 43).
(Figure
19).
41