HP 8/20q and SN6000 Overview Fibre Channel Switch Congratulations on your purchase of the HP 8/20q Rack-Mount Kit Quick Start and SN6000 Fibre Channel Switch Rack-Mount Kit. This document provides procedures for installing the Installation Instructions 8/20q and SN6000 Fibre Channel Switch in an HP-supported rack.
For proper airflow, the SFP+ media side (port side) of the device must face the front Check the contents of the 8/20q and SN6000 Fibre of the rack. Mounting the switch in this Channel Switch rack-mount kit shipping carton to...
Table 1 8/20q and SN6000 Fibre Channel Switch On the rack vertical posts, mark the holes that rack-mount kit hardware (continued) will be used by the rail flanges (three on each rear vertical post, two on each front vertical Item Description post).
Page 4
Using a flat washer and a 1/4-20 hex nut, fasten each slotted-rail end to the rear mounting bracket (Figure Figure 5 Fastening the rail to the rear mounting bracket Optional: Using two M6 machine screws, fasten the filler panel to the rear mounting brackets (Figure Figure 6 Installing the filler panel Page 4...