Epson LX-810 User Manual page 213

Problem
Several lines of
space occur in the
printout.
Skip over perforation
is set, but does not
work.
Skip over perforation
is set, but the skip
has shifted from the
perforation, or the
perforation does not
fall in the center of
the skip.
Solution
The paper may have too much slack.
Adjust the position of the sprockets to
take up any slack along the width of the
paper. Remove slack lengthwise by
pressing in and rotating the pull tractor
feed knob on the right. Refer to 5-23.
The paper thickness lever may not be set
correctly. Set the paper thickness lever to
match the thickness of your paper. Refer
to 2-22.
The paper may not meet the specifications.
Check that your paper is of the proper
size, weight, and thickness. Refer to 8-3.
Skip over perforation may be set. Set DIP
switch 2-3 to OFF.
You may have changed the DIP switches
with the power on. To make new DIP
switch settings effective, turn the power
off, then on again.
The page length for one page of the
continuous paper may be set incorrectly.
Set DIP switch 2-1 or use control codes
ESC C or ESC C 0 to set the correct page
length. Refer to 3-10, or 9-13.
The loading position of the paper may be
too high or too low. Use the micro-
adjustment feature to reset the loading
position. Refer to 3-12.
Troubleshooting
Options
7-27