Configuring Scan To Network; Configuring A Destination - Lexmark X463 Administrator's Manual

3
Enter the IP address or hostname and optional port for the network license server where the license is stored. You
can enter values for up to three separate servers.
4
Specify the Heartbeat Period (2–60 minutes), to designate how often the printer will ping the network license server
to check for updates and maintain access to an electronic license.
5
Specify the Number of Retries (1–5), to set the maximum number of times the printer can attempt to obtain a
license before quitting.
6
Click Apply.
Updating the network license
Using the Embedded Web Server
1
Click Solutions.
2
Under Installed Solutions, click the appropriate application link.
3
Click License.
4
Click Update License.
5
Select Network.
6
Click Update License.
Using MarkVision Professional
1
In MarkVision Professional, select the device where the application is installed.
2
Click Settings > Embedded Solutions > Solutions Management.
3
Under the appropriate application, click Update License.
4
In the Update License window, select Use a network license server.
5
Click Update License.

Configuring Scan to Network

The following procedure outlines in general terms how to configure a destination. For a comprehensive explanation of
each setting available when adding or editing a destination, see "Configuring destination settings" on page 10.

Configuring a destination

1
From the Embedded Web Server, do one of the following:
•
Click Settings > Device Solutions > Solutions (eSF) > Scan to Network.
• Click Settings > Embedded Solutions >Scan to Network.
2
Under Scan Destination, click Add.
Note: You can also edit or delete existing destinations.
3
Type a name for the destination.
4
Select Network Folder or FTP Address, and then configure the selected destination.
Configuring the application
9