Table Of Contents - SIIG UltraATA 133 PCI Quick Installation Manual

4. The Ultra ATA ribbon cable has two connectors. If
you install only one drive, connect it to the end
connector of the cable. On the other hand, if you
install two drives, connect the master drive to the
end connector of the cable and the slave drive in the
middle connector.
5. Reconnect the system power and other peripherals
to your computer.
Driver Installation
This section provides information on how to install the
UltraATA 133 PCI drivers for the following operating
systems:
Windows 98SE........................................................... page 5
Windows ME ............................................................. page 6
Verify Windows 98SE/ME Installation ..............page 6-7
Windows NT 4.0 ....................................................... page 7
Verify Windows NT 4.0 Installation ...................... page 8
Windows 2000 ........................................................... page 8
Windows XP/Server 2003 ....................................... page 9
Verify Windows 2000/XP/2003 Installation ...... page 10
Bios Configuration .................................................. page 10
4
Figure 2. Connecting the cable