Default-Setting Mode - Epson LQ-2090 User Manual

Setting
Software
0 slash
I/F (interface) mode
Auto I/F wait time
Parallel I/F bidirectional
mode
Packet mode
Auto CR (available in IBM
PPDS emulation mode)
A.G.M. (IBM PPDS);
available in IBM PPDS
emulation mode
Character table
International character
set for italic table
Font
Manual feed wait time
Buzzer
Roll paper
IBM character table
Low-noise mode

Default-setting mode

Follow the steps below to enter default-setting mode. If single-sheet
paper is loaded, you'll need to load a new sheet each time the printer
ejects a printed page.
1. Make sure the printer is on and paper is loaded. Then press the
buttons (Item
Menu
Menu lights turn on.
The printer enters default-setting mode and prints a line showing
which language is currently selected for printing the instructions.
(The selected language is underlined.)
Options (default in bold)
ESC/P, IBM PPDS
0,
Auto, Parallel, USB, Option
10 seconds, 30 seconds
Off, On
Auto, Off
Off, On
Off, On
Italic, PC 437, PC 850, PC 860, PC 863, PC 865, PC 861,
BRASCII, Abicomp, Roman 8, ISO Latin 1, PC 858,
ISO 8859-15
Italic U.S.A., Italic France, Italic Germany, Italic U.K.,
Italic Denmark 1, Italic Sweden, Italic Italy, Italic Spain 1
OCR-B, Orator, Orator-S, Script C, Roman T, Sans serif H
1 second, 1.5 seconds, 2 seconds, 3 seconds
Off, On
Off, On
Table 2, Table1
Off, On
and Set ) until the printer beeps and both the
U
Using the Control Panel
39