Epson LQ-2090 User Manual page 20

5. Slide the left sprocket
approximately
0.5 inch (12 mm)
from the far left
position and pull the
blue lever forward to
lock it in place. Then
slide the right
sprocket to match the
width of your paper,
but do not lock it.
6. Remove the front cover by
pulling it straight down.
7. Make sure your paper has a clean, straight edge. Then open both
sprocket covers and fit the first four holes of the paper, with the
printable side up, over the tractor pins.
8. Close the sprocket covers.
9. Slide the right sprocket to remove any slack in the paper; then lock it
in place by pushing the sprocket lock down.
20
Paper Handling