Changing The Printer's Default Settings - Epson LQ-2090 User Manual

2. Press the Pitch button until the three Pitch lights indicate the desired
pitch. (The pitches available depend on which font you select.)
N N O
N O N
N O O
O N N
O N O
O O O
= On, = Off
O N

Changing the Printer's Default Settings

While you can often change the printer's settings through your software
or printer driver, you may sometimes need to change one or more of the
printer's default settings. There are two ways to do this:
Using the Epson Remote Configuration Manager on the printer
software CD-ROM. (See page 15.)
Using the printer's control panel default-setting mode.
For instructions on using the Remote Configuration Manager, see the
online Remote Configuration Manager User's Guide on the CD-ROM. To use
the control panel, see below. For detailed information about default
settings, see the Reference Guide. The following table shows the options
available for each printer setting.
Setting
Page length for front
tractor
Page length for rear
tractor
Skip over perforation
Auto tear-off
Auto line feed
Print direction
38
Using the Control Panel
10 cpi
12 cpi
15 cpi
17 cpi
20 cpi
PS
Options (default in bold)
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12,
14, 17
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12,
14, 17
Off, On
Off, On
Off, On
Bi-D, Uni-D