Table of Contents
Advertisement
Programming the Remote
You nutd perfin'm step 4 within 10
seconds of step 3, or you must start
again from step 3.
You must perform step 5 within 10
seconds of step 4, or you must start
again from step 3. To cancel the
operation, press the ENTER button.
The DSS receiver's
remote control is preset at the factory to operate
Sony brand TVs. If you have a TV other than Sony brand, or you have a
cable box that you want to control with the DSS receiver's
remote, use
the following
procedures
to program
the remote to control these
components.
Note
Your components must have infrared (IR) remote control capability in order to
be used with the DSS receiver's remote.
To program the DSS receiver's remote:
1
Manually
turn on the component
that you want to program.
2
Turn to "Programmable
Codes" on page 71, and find the three-
digit code number
for your component.
If more than one code
number
is listed, use the number
listed first to complete the
following
procedures.
3
Press the CODE SETbutton.
4
Press the FUNCTION
button
(CABLE or TV) for the component
you're setting up.
5
Enter the three-digit
code number.
6
Press the ENTER button.
To Check if the Code Number Works
Use the following
procedure
to make sure the code you've entered
works:
1
2
Aim the DSS receiver's
remote at the component
and press the
POWER button
that corresponds
to that component.
If the component
responds,
try the CH+ and CH- buttons.
If the
component
responds,
you're done. Use the space below to record
the code numbers
for your components.
TVCode
Cable BoxCode
If the code doesn't
work:
Try programming
the remote using the other codes listed for your
component.
If you cannot get your component
to respond
to the DSS receiver's
remote -- even after trying all the code numbers
for your
component
-- your component
may not be compatible
with the
DSS receiver's
remote. If this happens,
you must use your
'
n
component
s ow
remote to operate
it.
70
Appendix:
Other Information
Advertisement
Table of Contents
