Sony STR-V333ES Operating Instructions Manual page 47

Automatic Tuning Preset Tuning
For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 46.
1
Rotate FUNCTION to select the tuner.
The last received station is tuned in.
2 Press FM/AM to select the FM or AM band.
Press TUNING + or TUNING -.
Press tire + button to scan tiom low to high; press the
button to scan from high to low.
The receiver stops scanning whenever a station is
received.
When the receiver reaches either end of the
band
Seanning is repeated in tlre same direetion.
4
To continue scanning, press TUNING + or TUNING -
again.
For details on the buttons used in this section, see "Brief
descriptions of buttons
used to receive broadcasts" on
page 46.
Before tuning to preset stations, be sure to preset thein by
performing steps on "Presetting radio stations" below.
I
Rotate FUNCTION to select the tuner.
Tire last received station is tuned in.
2 Tune in the station that you want to preset using
Direct Tuning (page 46) or Automatic Tuning (page
47).
3 Press MEMORY.
"MEMORY" appears in the display for a few seconds.
Do Steps 4 and 5 before "MEMORY" goes out.
Press PRESET TUNING + or PRESET TUNING - to
select a preset number.
If "MEMORY" goes out before you press tire preset
numben start again fl'om Step 3.
5 Press MEMORY again to store the station.
If "MEMORY" goes out before you press tire preset
number, start again fl'Oln Step 3.
6 Repeat Steps 2 to 5 to preset another station.
1"ochange a preset number to another station
Do Steps 1to 6 to preset tire new station to the number.
Note
If the AC power coM is disconnected for about two weeks, all the
preset stations will be cleared fi'om the receiver's memory, and
you will have to preset the stations again.
¢D
te_
W
e_
47