Speaker System - Sony STR-V333ES Operating Instructions Manual

Speaker System Hookup
This receiver corresponds with 6. l channel decording. If
yOU do not place a center speaker, you can place a rear
center speaker. For details, see page 18.
Speaker cords (not supplied)
One fbr each fiont, rear, and center speaker
(-) _ _ (-)
Monaural audio cord (not supplied)
One for an active sub woofer
Black @ _ Black
@ @
Active sub woofer
Rear speaker (R)
Connect the To the
Front speakers (8 or 41)ohm) SPEAKERS FRONT A terminals
Additional pair of front SPEAKERS FRONT B terminals
speakers (8 or 41)ohm)
Rear speakers (8 or 41)ohm) SPEAKERS REAR terminals
Center speaker or rear center SPEAKERS CENTER terminals
speaker :_> ( 8 or 41)ohm)
Active sub woofer SUB WOOFER PRE OUT 2}
I) See "Speaker impedance" on fl_enext page.
g) You can connect an active sub woofer to either of the two jacks. The
remaining jack can be used to connect a second active sub woofer
J; ff vvu do not use a center speaker, you can connect a rear center
speaker For details, see page !&
Front speaker (R) Front speaker (L)
FRONT
SPEAKERS B
IMPEDANCE
SELECTOR
Rear speaker (L)
@ @
Centerspeaker
(Rear center speaker)
"_"aTo connect certain speakers to another amplifier
Use the PRE OUT jacks. The same signal is output fi"om both the
SPEAKERS jacks and the PRE OI.IT jacks. For example, if you
want to connect just the front speakers to another amplifier,
connect that amplifier to the PRE OUT FRONT L and R jacks.
• Twist the stripped ends of the speaker cords about
2/3 inch (10 into). Be sure to inatch the speaker cord to
the appropriate terminal on the components: + to + and
to . If the cords are reversed, the sound will be
distorted and will lack [)ass.
• If you use fi"ont speakers with low maximum input
rating, adjust the volume caref\flly to aw)id excessive
output on the speakers.
O
O
5'
e-
5'
€-
o
o
g
15