Assembly - Weslo PURSUIT 310 CS User Manual

ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing matedals untilassembly is completed.
Assembly requires the included tools and your own adjustable wrench _, Phillips screw-
driver (_3_-, and pliers _.
Use the part drawings below to identifythe small parts used in assembly.The number in parenthesis below
each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers
to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a
part is not in the parts bag, check to see if it has been pre-attached,
M8 Split M8 Nylon M10 Nylon
Washer (42)-10 Locknut (10)-4 Locknut (33)-4
M4 x 16mm
Screw (49)-4
M8 x 15mm Button
Screw (34)-6
MIO x 65mm Carriage Bolt (30)-4
1. While another person lifts the front of the Frame (1)
slightly,attach a Stabilizer (2) with two M1O x 65mm
Carriage Bolts (30) and two M10 Nylon Locknuts(33).
2. While another person lifts the rear of the Frame (1)
slightly,attach a Stabilizer (2) with two M10 x 65mm
Carriage Bolts (30) and two M10 Nylon Locknuts (33).
33
3O
2
33
2
30
4