Canceling Aeb - Canon EOS 10D Digital Instruction Manual

Canceling AEB

•
Neither flash nor bulb exposures can be used in AEB mode.
•
If you set mirror lockup with C.Fn-12-1 (→p.149) and then use AEB, single-frame
shooting takes effect even if the drive mode is set to continuous shooting.
•
If the drive mode is single frame, press the shutter button for each bracketed shot.
•
AEB can also be set in combination with exposure compensation. If you set the
exposure compensation amount beyond the displayable range, the indicator will look
as shown below. However, the exposure compensation amount will still remain valid.
For < > < > <
Exposure compensation by –2 stops and + / – 1 stop AEB
For < >:
–2 stops and + / – 1 stop AEB
•
C.Fn-06-1, enables the exposure compensation amount to be set in 1/3-stop
increments. (→p.147)
In this case, the AEB amount will be displayed as shown below.
+ / – 1/3 stop AEB
•
C.Fn-09-2/3, changes the bracketing sequence to decreased exposure, standard
exposure, and increased exposure. (→p.148)
•
C.Fn-09-1/3, can prevent AEB from being canceled after you turn the <
< >, change lenses, have flash-ready, replace the battery, or replace the CF card.
(→p.148)
•
Follow steps
<
•
AEB will also be canceled automatically if you turn
the < > switch to <
flash-ready, replace the battery, or replace the CF
card.
> < >:
: –1/3 stop
Auto Exposure Bracketing
1 2
and to set the AEB amount to
>.
>, change lenses, have
+ / – 2/3 stop AEB
: –2/3 stop
6
> switch to
91