Status Clear And Memory Clear Operations; Status Clear - TEC MA-516-100 SERIES Owner's Manual

27. Status Clear and Memory Clear Operations

The operations described in this chapter are provided for initial start-up of the machine or emergency but not to be
operated as part of daily routines. Do not perform any of these operations unless it is really necessary.

Status Clear

The operation defined as "Status Clear" will only clear an error or key-locked condition that disables normal operations
(though it seldom happens). Thus neither the sales data nor the programmed data will be cleared by a Status Clear
(except that when a Status Clear is operated to clear a key-locked condition during a sale, the sale item data already
entered for the current sale will be cleared).
The Status Clear also has the function to obtain the condition "after all sales data resets" (as if all sales data had been
reset) but will not actually affect any sales data. Such a condition is required in some programming operations and
is usually obtained by taking the required reset reports. However, when you do not want the sales data to be reset
because it is still in the business hours, etc., this function of the Status Clear will be effective. But be careful in using
the function; depending on the programming item, sales data resets may really be necessary instead of a Status
Clear, to keep consistency between the programmed data and the sales data.
Operating Procedure
Condition: Any time, outside or during any operation sequence
Operation:
Remove the plug of the register's power cord from the wall outlet (to turn OFF the power).
Use the S Key to turn the
Control Lock to "BLIND".
Plug in the cord (to turn ON the power).
A Status Clear receipt is issued.
X
MGR
-
REG
OFF
Z
(BLIND)
SET
Status Clear Symbol Line
- 155 -
EO1-11116
MA-516-100 SERIES
Zero-amount Display & Print Format
(may vary depending on the designation in the
last "Sales Memory Clear" or "All Memory
Clear" (refer to the following pages.) Initial,
Format 0.00