Outdoor Unit - Toshiba RAS-13UAV-E2 Service Manual

11-3. Outdoor Unit

No. Part name
1
Common
procedure
2
Front cabinet
Procedures
1. Detachment
1) Stop operation of the air conditioner, and turn off
the main switch of the breaker for the air
conditioner.
2) Remove the valve cover. (ST1T 4 x 10s 1 pc.)
After removing screw, remove the valve cover
pulling it downward.
3) Remove wiring cover (ST1T 4 x 10s 2 pcs.),
and then remove connecting cable.
4) Remove the upper cabinet.
(ST1T 4 x 10s 2 pcs.)
After removing screws, remove the upper
cabinet pulling it upward.
2. Attachment
1) Attach the upper cabinet.
(ST1T 4 x 10s 2 pcs.)
Hook the rear side of the upper cabinet to
claw of the rear cabinet, and then put it on the
front cabinet.
2) Perform cabling of connecting cable, and attach
the wiring cover.
Insert the upper part into the upper cabinet,
insert claw which has been hooked to the
lower part into the square hole, and then fix it
with screw. (ST1T 4 x 10s 1 pc.)
3) Attach the valve cover. (ST1T 4 x 10s 1 pc.)
Insert the upper part to the upper cabinet,
set hook claw of the valve cover to square
holes (at three positions) of the main unit,
and attach it pushing upward.
1. Detachment
1) Perform work of item 1 of 1.
2) Remove screw (ST1T 4 x 10s 2 pc.) of the
front cabinet and inverter cover and screws
(ST1T 4 x 10s 3 pcs.) of the front cabinet and
lower part.
The left side of the front is made to insert to
the rear cabinet, so remove it pulling upward.
2. Attachment
1) Insert claw at the left side of the front into the
rear cabinet.
2) Hook the lower part at the right side of the front
to concave part of the bottom plate. Insert claw
of the rear cabinet into square hole of the front
cabinet.
3) Attach the removed screws to the original
positions.
Square hole
– 76 –
FILE NO. SVM-03008
Remarks
Upper cabinet
Wiring cover
Valve cover
Claw
Concave section