Toshiba RAS-13UAV-E2 Service Manual page 36

8-6-2. Names and functions of indications on
remote control
[Display]
All indications, except for clock time indication, are
indicated by pushing the START/STOP button.
1 Transmission mark 1 1
1 1
This transmission mark , indicates when the
remote controller transmits signals to the indoor
unit.
2 Mode display 2 2
2 2
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover
control, : Cool, : Dry,
3 3 Temperature display 3
3 3
Indicates the temperature setting (17 C to 30 C).
When you set the operating mode to
no temperature setting is indicated.
4 4 Louver operation display 4
4 4
Indicates the louver positioning and operation.
Five selectable positions
Swing
5 5 FAN speed display 5
5 5
Indicates the selected fan speed. AUTO or one of
five fan speed levels (LOW
MED , MED +
be indicated.
Indicates AUTO when the operating mode is either
AUTO or : Dry.
3 1 2 8
AUTOA
9 7
In the illustration, all indications are indicated for explanation.
During operation, only the relevant indications will be indicated on the remote control.
: Heat, : Fan only)
: Fan only,
Automatic
, , , ,
+
, LOW ,
, HIGH ) can
4
A
B
5 6
6 6 6 6 6 TIMER and clock time display
The time set for timer operation or clock time is
indicated.
The present time is always indicated except for
TIMER operation.
7 7
7 7 Hi-POWER display 7
Indicates when the Hi-POWER operation starts.
Push the Hi-POWER button to start and push it
again to stop the operation.
8 8
8 8 8
(MEMORY) display
Flashes for 4 seconds when the MEMO button is
pushed during operation.
mark is indicated when keeping the button
depressed for more than 4 seconds while the
mark is flashing.
Push another button to turn off the mark.
9 9 9 ECO TIMER display 9 9
Indicates when the ECO TIMER is in operation.
Each time you push the ECO button, the display
changes in the sequence of 1,3,5 or 9h.
A
– 35 –
FILE NO. SVM-03008
A
B