Filter Check Lamp - Toshiba RAS-13UAV-E2 Service Manual

8-4-2. How to cancel auto restart function
To cancel auto restart function, proceed as follows:
Repeat the setting procedure: the unit receives the
signal and beeps three times.
The unit will be required to be turned on with the
remote control after the main power supply is turned
off.
When the system is on standby (Not operating)
Operation
Push [TEMPORARY] button for more
than three seconds.
TEMPORARY button
When the system is operating
Operation
Push [TEMPORARY] button for more
than three seconds.
TEMPORARY button
While this function is being set, if the unit is in operation, the orange lamp is on.
8-4-3. Power failure during timer operation
When the unit is in timer operation, if it is turned off
because of power failure, the timer operation is
cancelled. Therefore, set the timer operation again.
NOTE:
The Every Timer is reset while a command signal can
be received from the remote controller even if it
stopped due to a power failure.

8-5. Filter Check Lamp

When the elapsed time reaches 1000 hours, the filter
check lamp indicates. After cleaning the filters, turn off
the filter check lamp.
The unit is on standby.
The unit starts to operate.
The unit beeps three times
0
and continues to operate.
3S
If the unit is not required to operate at this time, push [TEMPORARY]
button once more or use the remote control to turn it off.
The unit is in operation.
The unit stops operating.
The unit beeps three times.
0
3S
If the unit is required to operate at this time, push [TEMPORARY]
button once more or use the remote control to turn it on.
– 33 –
Motions
The orange lamp is on.
After approx. three seconds,
The lamp changes from
orange to orange.
Motions
The orange lamp is on.
The orange lamp is turned off.
After approx. three seconds,
8-5-1. How to turn off filter check lamp
Push [FILTER] button on the remote control.
Or push [TEMPORARY] button on the indoor unit.
Then we have to clarify it.
NOTE :
If [TEMPORARY] button is pushed while the filter
check lamp is not indicating, the indoor unit will start
the automatic operation.
When you want a temporary operation while the filter
lamp lights, put out the lamp once, and then push the
TEMPORARY button.
FILE NO. SVM-03008