General Information - Superior SDV35-N Care And Operation Instructions Manual

General Information

These fireplace models covered in this manual
are direct-vent sealed combustion gas fireplace
heaters designed for installation into manufac-
tured homes and site built residential homes.
These direct-vent appliances operate with the
combustion chamber completely isolated from
the indoor environment.
All air for combustion is brought in from the
outside and exhaust gases are vented through
the same direct-vent, co-axial (intake/exhaust)
vent system.
These Millivolt appliances have a millivolt
gas control valve with piezo ignition system.
The blower on fireplace will require electrical
power to be installed at the time of appliance
installation.
These appliances comply with National
Safety Standards and are tested and listed by
OMNI-Test Laboratories, Inc. (Report No.116-
F-29-5) to ANSI Z21.88 (in Canada, CSA-2.33),
and CAN/CGA-2.17-M91 in both USA and
Canada, as vented gas fireplace heaters.
The Installation must conform to local codes
or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA
54-latest edition, or the Natural Gas and
Propane Installation Code, CSA B149.1-latest
edition. The appliance, when installed, must
be electrically grounded in accordance with
local codes or, in the absence of local codes,
the latest edition of the National Electrical Code,
ANSI/NFPA 70, or the Canadian Electrical Code,
CSA C22.1 - latest editions.
The vent termination is hot while in
operation and for a period of time fol-
lowing the use of the fireplace. Young
children should be carefully supervised
when they are in the same area as a
hot termination. To prevent contact with
hot surfaces, we recommend the use of
a termination guard. See Page 17 for
ordering information.
These fireplaces are designed as supple-
mental heaters. Therefore, it is advisable
to have an alternate primary heat source
when installed in a dwelling.
These appliances must not be connected
to a chimney or flue serving a separate
solid fuel burning appliance.
6
INSTALLATION, SERVICE,
AND MAINTENANCE
IMPORTANT: Improper installation,
adjustment, alteration, service, or
maintenance can cause injury or
property damage. Refer to this manual.
For assistance or additional information,
consult a qualified installer, service
agency or the gas supplier.
Only trim kit(s) supplied by the
manufacturer shall be used in the
installation of this appliance.
Draft relief openings must not be
covered or blocked.
These appliances must not be
connected to a chimney or flue serving a
separate solid fuel burning appliance.
Any change to this appliance and/or
its operating controls is dangerous.
Improper installation or use of this
appliance can cause serious injury or
death from fire, burns, explosion or
carbon monoxide poisoning.
Carbon Monoxide Poisoning: Early
signs of carbon monoxide poisoning
are similar to the flu with headaches,
dizziness and/or nausea. If you
have these signs, obtain fresh air
immediately. Turn off the gas supply to
the appliance and have it serviced by
a qualified professional, as it may not
be operating correctly. Some people
are more affected by carbon monoxide
than others, including pregnant women,
people with heart or lung disease or
anemia, those under the influence of
alcohol, and those at high altitudes.
Turn off gas and electrical power to the
fireplace and allow it to cool before
cleaning or servicing the appliance.
OPERATION
Do not operate appliance with the glass
front removed, cracked, or broken.
These fireplaces are vented gas
appliances. Do not burn wood or other
material in these appliances.
This appliance is only for use with the
type of gas indicated on rating plate.
This appliance is not convertible for use
with other gases, unless a certified kit is
used.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
These appliances are designed to
operate on natural gas or propane
gas only. The use of other fuels or
combinations of fuels will degrade the
performance of this system and may be
dangerous.
Provide adequate clearances around
air openings and adequate accessibility
clearance for service and proper
operation. Never obstruct the front
openings of the appliance.
Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control that
has been under water.
WARRANTY
Failure to comply with the installation
and operating instructions provided
will result in an improperly installed
and operating appliance, voiding its
warranty.
Do not attempt to alter or modify the
construction of the appliance or its
components. Any modification or
alteration may void the warranty,
certification, and listings of this unit.