Table of Contents
Advertisement
LOG AND VOLCANIC STONE INSTALLATION
PROCEDURE:
The log set foam package is located in the firebox
and the bags of decorative volcanic stone and
the glowing embers (rockwool) are located in
the control compartment. Refer to the follow-
ing information and Figures 52 through 55 for
detailed placement instructions.
Install the decorative volcanic stone and
glowing embers (rockwool):
Spread the decorative volcanic stone on the
simulated brick floor of the firebox around
the burners to simulate ashes. Maintain a 1/2
inch (13 mm) gap between the bottom of the
horizontal grate section and the top of the pile of
decorative volcanic stone. Place a few quarter-
sized pieces of the glowing ember material
on the pan burner in front of the burned out
area on both sides of the log set. The glowing
embers may touch one another, but should not
overlap each other.
29
Install the unitized log set:
a. The bottom of the log set is notched to ac-
commodate the pilot.
b. Place the log set so that the four inner notches
on the underside of the log set fit over the
four risers located on the burner ends. See
Figure 53. This procedure is accomplished
primarily by feel, as the log set masks the
burner risers as it is being installed.
c. As a final check for correct log set placement,
check that the four outer notches on the
underside of the log set fit over the burner
tines as indicated in Figure 53.
Burner / Grate Location Reference
(see Figures 54 and 55)
Note: If the burners have been removed for
any reason, rear burner must be installed
before front burner. See Figures 54 and 55.
Glowing Embers
Separate into Quarter
Size (separate) Pieces
Bag of Glowing
Embers (rockwool)
Figure 52
REFERENCE
Firebox Accessories / Parts
Cat. No.
Model No.
Description
88L53
FGE
Bag of Glowing Embers
Bag of Decorative
80L42
FDVS
Volcanic Stone
unitized Log Set
Figure 53
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
BURNER POSITIONING
NOTE: INSTALL REAR BURNER FIRST,
THEN FRONT BURNER.
BRACKET A
REAR BURNER
FRONT BURNER
Note: The burners are not identical. Position them so
that the circular burner ports run as shown. Note
especially the vertical run of ports relative to the pilot
burner. Bracket A on the rear burner will interfere
with the pilot burner if an attempt is made to install
the rear burner in the front burner's position.
Figure 54
NOTE: INSTALL REAR BURNER FIRST,
THEN FRONT BURNER.
Outer Log
Notch Location
Riser - Inner Log
Notch Location
Outer Log
Notch Location
FRONT BURNER
FIREBOX SUBFLOOR
FRONT OF FIREPLACE
LOG NOTCH LOCATION RELATIVE TO BURNER
Figure 55
Proper Burner Flame Appearance
Volcanic Stone
BURNER
PORTS
PILOT
BURNER
REAR BURNER
Outer Log
Notch Location
Riser - Inner Log
Notch Location
Outer Log
Notch Location
Pilot Assembly
29
Advertisement
Table of Contents
