Sony HDW F900R - CineAlta Camcorder - 1080p Operation Manual page 67

The AUTO IRIS page disappears from the viewfinder
screen.
6
Turn the MENU knob to change the reference value.
Note
When you push the MENU knob in ECS or SLS
mode, the camcorder enters a mode where you can
change the frequency in the ECS mode or the number
of frames in the SLS mode by turning the MENU
knob.
1)The SLS mode is effective only when an optional HKDW-905R
extension board is installed in the camcorder.
The changed reference value is retained until the
power of the camcorder is turned off.
Even if the reference value is changed, it reverts to the
standard value every time the power is turned on.
To open the iris by 0.25 stop:
Turn the MENU knob further counterclockwise as
seen from the front of the camera.
One bar (s) appears in the upper part to the left of the
F number in the iris indication.
To open the iris by 0.5 stop:
Turn the MENU knob further counterclockwise as
seen from the front of the camera.
One bar (x) appears in the upper part to the left of the
F number in the iris indication.
To open the iris by 0.75 stop:
Turn the MENU knob further counterclockwise as
seen from the front of the camera.
Two bars (sx) appear in the upper part to the left of
the F number in the iris indication.
To open the iris by 1 stop:
Turn the MENU knob counterclockwise as seen from
the front of the camera.
Two bars (xx) appear in the upper part to the left of
the F number in the iris indication.
To close the iris by 0.25 stop:
Turn the MENU knob clockwise as seen from the front
of the camera.
One bar (s) appears in the lower part to the left of the
F number in the iris indication.
To close the iris by 0.5 stop:
Turn the MENU knob clockwise as seen from the front
of the camera.
One bar (x) appears in the lower part to the left of the
F number in the iris indication.
To close the iris by 0.75 stop:
Turn the MENU knob clockwise as seen from the front
of the camera.
Two bars (sx) appear in the lower part to the left of
the F number in the iris indication.
To close the iris by 1 stop:
1)
Turn the MENU knob clockwise as seen from the front
of the camera.
Two bars (xx) appear in the lower part to the left of
the F number in the iris indication.
Opening the lens iris
Iris opened by 0.25 stop
Iris opened by 0.5 stop
Iris opened by 0.75 stop
Iris opened by 1 stop
Closing the lens iris
Iris closed by 0.25 stop
Iris closed by 0.5 stop
Iris closed by 0.75 stop
Iris closed by 1 stop
When an optional RM-B150/B750 Remote Control
Unit is connected
The IRIS control knob of the RM-B150/B750 can be used
for lens iris setting. In this case, the bar display (s) does
not appear.
Selecting the automatic iris window
1
Follow steps 1 and 2 in "Changing the reference
value" (page 66) to display the AUTO IRIS page.
2
Turn the MENU knob to move the
WINDOW IND, then push the MENU knob.
b
The mark on the left of IRIS WINDOW IND
changes to a z mark, and the z mark on the left of the
setting changes to a ? mark.
3
Turn the MENU knob until ON appears, then push the
MENU knob.
The z mark returns to a
returns to a z mark.
The currently selected auto iris window appears on the
screen.
Changing the Reference Value for Automatic Iris Adjustment
b
mark to IRIS
b
mark, and the ? mark
67