Star Trac E-UB 8100 Owner's Manual page 13

2. Install the Display Weldment
NOTE: You will need someone to assist you to install the display weldment.
Have the person who is assisting you hold the display weldment while you
route the display cables and connect the neck.
Have your helper hold the neck tube close to the base, route the main I/O
cable, auxiliary power and coaxial cable up the full length of the display
neck then make sure the contact heart rate cable is clear before seating
the neck on the base. The See Figure 2a. Secure the neck tube with 4 M8
allen head bolts and washers and torque of 8-10 lbs-ft.
3. Install Adjustable Heart Rate Bar
Locate the adjustable heart rate bar.
Connect the cable from the hole in the neck
tube to the cable from the adjustable heart
rate bar.
Taking care to not pinch the cable assemble, mount the
adjustable heart rate bar to the neck tube with four M6 x 25 mm
allen bolts and four star washer. Tighten all four bolts to a
torque of 8-10 lbs-ft.
Check the adjustable heart rate bar for proper operation by
pressing the red button and sliding the heart rate bar back and
forth to verify normal operation without difficulty.
S S TAR TRAC E SERIES BIKES OWNER'S MANUAL
Step 2a
Step 2
Step 3a
Step 3b
13