Star Trac Fitness S-TR Owner's Manual page 21

4. Install the Handrails
NOTE: Both handrails are installed in a similar
manner.
Remove the four M10 X 140 hex head screws and hex
nuts from the base assembly. Discard the hex nuts.
Insert the connecting tube of the handrail into the
handrail stub in the display console. Slide the
handrail fully into the console.
5. Connect the Display Cable
Slide the neck shroud up to gain access to the display
cable. Connect the display cable to the base assembly
power cord.
STAR TRAC S SERIES TREADMILLS O
If necessary, rotate the handrail slightly to align the
display console handrail stub with the threaded hole
in the handrail connecting tube. Secure the handrail
to the display console with two M6 X 50 Allen head
bolts and D=6 lockwashers two M8 X 25 Allen Set-
Screw. Secure the handrail to the treadmill base
assembly with two M10 X 140 hex head screws.
Tighten all screws securely.
Install the remaining handrail in a similar manner.
Slide the neck shroud down into position on the base
assembly shroud. Secure the neck shroud to the base
assembly using two M6 X 25 Allen head bolts and
D=6 lockwashers.
' M
WNER S ANUAL
M6X50 ALLEN HEAD BOLTS
D=6 LOCKWASHER
M8X25 ALLEN
SET-SCREW
M10X140 HEX HEAD SCREWS
NECK
SHROUD
M6X25 ALLEN HEAD BOLT
D=6 LOCK WASHER
HANDRAILS
21