Stamina 55-1537C Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
STEP 7:
Attach the
holes facing down. Secure the
NOTE:
The four adjustment holes in the
four different positions. Start with one of the center positions and adjust if necessary. Use the outer
position if users are taller than average. Use the inner position if users are shorter than average.
STEP 8
HEEL HOLDER TUBE(13)
Insert the
BOLT(M6 x 47mm)(60), WASHERS(M6 x ø16 x 1.5mm Thick)(68),
and secure with
NUT(M6)(66).
Place a
HEEL HOLDER TUBE(13)
onto the
STEP 9
OUTER PAD TUBE(17)
Insert the
INNER PAD TUBE(16)
the
TUBE(16), OUTER PAD TUBE(17)
BOLT(M6 x 35mm)(59)
with
WARNING: PAD TUBES(16, 17)
The
The ends must be pointed downward to properly secure the users feet in place during inversion.
Improper assembly will allow the user's feet to come loose and the user will fall from the
Inversion System.
FOOTREST(11)
onto the
FOOTREST(11)
HEEL HOLDER BRACKET(14)
together. Repeat on other side.
through the hole on the
OUTER PAD TUBE(17).
into the
, and
ARC WASHER(M6)(71).
and
HEIGHT ADJUSTMENT BEAM(10)
in place with the
FOOTREST(11)
allow the
through the hole on the
onto a
HEIGHT ADJUSTMENT BEAM(10).
HEIGHT ADJUSTMENT BEAM(10),
must be assembled with the ends pointed downward as shown.
9
ADJUSTMENT KNOB(12).
FOOTREST(11)
HEIGHT ADJUSTMENT BEAM(10)
HEEL HOLDER(15),
Align the holes on the
then bolt them together
with the adjustment
to be attached in
NYLOCK
and
then slide them
Insert
INNER PAD
Elite