Hardware Identification Chart - Stamina 55-1537C Owner's Manual

Elite inversion system
Table of Contents

Advertisement

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers, the
end of the bolts, or screws on the circles to check for the correct diameter. Use the small scale to check the
length of the bolts and screws.
3/16"
1/4"
0
1/2
1
0
10
20
6
NOTICE: The length of all bolts and screws except those with flat heads is
measured from below the head to the end of the bolt or screw.
Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
5/16"
3/8"
1/2
2
1/2
30
40
50
60
8
10
Part No. and Description
59
60
62
63
64
79
66
67
80
68
69
81
70
71
1/2"
3
1/2
4
70
80
90
100 110 120 130 140 150
MILLIMETERS
12
Bolt, Button Head (M6 x 1 x 35mm)
Bolt, Button Head (M6 x 1 x 47mm)
Bolt, Button Head (M8 x 1.25 x 15mm)
Bolt, Button Head (M8 x 1.25 x 50mm)
Bolt, Button Head (M8 x 1.25 x 55mm)
Bolt, Button Head (M10 x 1.5 x 60mm)
Nylock Nut (M6 x 1)
Nylock Nut (M8 x 1.25)
Nylock Nut (M10 x 1.5)
Washer (M6 x
ø
16 x 1.5mm Thick)
Washer (M8)
Washer (M10)
Arc Washer (M8)
Arc Washer (M6)
5
INCHES
1/2
5
1/2
length
length
6
in.
mm.
Qty
1
1
4
2
2
2
1
2
2
2
8
4
2
1

Advertisement

Table of Contents
loading

Table of Contents