Uninstalling The Landesk Software Agent; Using The Configuration/Setup Utility Program; Using The Raid Configuration Programs - Lenovo ThinkServer TD100 Installation Manual

2. In the toolbar on the left, click Add/Remove Windows Components to launch
3. In the Components list, click Management and Monitoring Tools; then, click
4. Select Simple Network Management Protocol; then, click OK.
5. Click Next to continue the wizard.
6. If prompted, insert the original Windows operating system CD. If the autorun
7. Click Finish.

Uninstalling the LANDesk Software Agent

If the Core Server has LANDesk agents on it from a previous Management Suite
release, it will fail the autorun prerequisite check. You must remove the old agents
by running uninstallwinclient.exe from the \Program Files\LANDesk\
ManagementSuite folder.

Using the Configuration/Setup Utility program

The Configuration/Setup Utility program is part of the BIOS code. You can use it to:
v Change interrupt request (IRQ) settings
v Change the startup drive sequence
v Configure serial-port assignments
v Enable USB keyboard and mouse support
v Resolve configuration conflicts
v Set the date and time
v Set passwords and security settings
To start the Configuration/Setup Utility program, complete the following steps:
1. Turn on the server.
2. When the prompt Press F1 for Configuration/Setup appears, press F1. If an
3. Follow the instructions on the screen.
See the User Guide on the ThinkServer Documentation DVD for more detailed
information about the Configuration/Setup Utility program.

Using the RAID configuration programs

Note: RAID options and HostRAID are not supported on the SCO 6.0 and
Use the RAID Configuration Utility program and Adaptec RAID Configuration Utility
program to configure and manage redundant array of independent disks (RAID). Be
sure to use these programs as described in this document.
The ServeRAID 8k-l SAS Controller that comes installed in some models (hot-swap
SAS and hot-swap SATA models) enables you to configure multiple physical SAS or
SATA hard disk drives to operate as logical drives in a disk array. If your server
the Windows Components Wizard.
Details.
launches when you insert the CD, close it. The Windows Components Wizzard
will automatically detect and install the necessary files.
administrator password has been set, you must type the administrator password
to access the full Configuration/Setup Utility menu.
UnixWare 7.14 operating systems.
Chapter 4. Configuring the server
53