Belt Guide Adjustment; Check Andadjustthecables - Sears Craftsman C950-52943-0 Owner's Manual

MAINTENANCE
BELT GUIDE ADJUSTMENT
1. Remove sparkplug wire.
2. Have someone engage theaugerdrive.This will engage augeridler
pulley(A, Figure35).
3. Measure thedistance between the beltguide(B)and belt(C).The
distance shouldbeabout1/8inch(3 ram).
4. If adjustment i s necessary, loosenbeltguidemountingbolt. Move
beltguideto thecorrectposition.Tighten mountingbolt.
5. Installbeltcover.
6. Connect s parkplugwire.
®
AdjustingBeltDrive
Figure 35
CHECK ANDADJUSTTHECABLES
Thecables areadjusted atthefactoryandnoadjustment s houldbe
necessary. If thecableshavebecome stretched or aresaggingadjustment
will benecessary.
Whenever beltsareadjusted or replaced, thecables will needto bead-
justed.
Tocheckfor correctadjustment, unhook"Z" fitting (A,Figure36) atclutch
lever(B).
1. Moveclutchlever(B)to thefull forwardposition(justcontacting
plasticbumper). H oldingcabletight, notepositionof fittingto holein
clutchlever.
2. Thecenter of the"Z" fitting (A)shouldbebetween thecenter andtop
of theholein theclutchlever(B).
©
Auger Drive Cable
[,_ ARNING: Drain the gasoline outdoors, away from fire
or flame.
1. Remove thegasfromthegastank.Standthesnowthrowerupon the
frontendof theaugerhousing.
2. Pushcable(A,Figure37) throughspring(B)to expose thethreaded
portionof thecable.
3. Holdsquare end ofthreaded portionwith pliersandadjustIocknut
(C) in or outuntil correctadjustment i s reached.
4. Pull cablebackthroughspringand connect c able.
i
ChecktheCables Figure36
AdjustingAugerDriveCable Figure37
28