4.
Carefullypivot the snow throwerup and forwardso that it restson
theauger housing.
5.
Removethe frame coverfrom the undersideof the snow thrower
by removingfourself-tappingscrewswhich secureit. See Figure
23.
6.
Removethe beltas follows.Referto Figure24.
a.
Loosenand removetheshoulderscrewwhich actsas a belt
keeper.
b.
Unhookthesupport bracketspringfrom theframe.
7.
Removethe beltfrom aroundthe augerpulley,and slip the belt
betweenthesupport bracketand the augerpulley.See Figure25.
8.
Reassemble auger beltby followinginstructionsin reverseorder.
NOTE:Do NOTforgetto reinstallthe shoulderscrewand reconnect
the springto theframe after installinga replacementaugerbelt.
f
m
i
i
Drive Belt
Toremoveand replaceyoursnow thrower'sdrive belt,proceedas
follows:
1.
Topreventspillage,placea pieceof plasticwrap underthe gas
capand tightensecurely.
2.
Removethe plasticbeltcoveron the front of the engineby remov-
ing the two self-tappingscrews.See Figure21 on previouspage.
3.
Removethe beltas follows.Referto Figure26.
a.
Rollthe augerbelt off the enginepulley.
b.
Use a wrenchto pivotthe idler pulleytowardthe right.
c.
Lift the drivebelt off engine pulley.
f-
ii
i
\/
Figure23
f
f
Figure24
• i
Figure25
J
,,J
iii
Figure26
J
2O