ProForm crosswalk sport User Manual page 9

.
Have a second person hold the console assem-
bly near the Right Upright (78). Cut the plastic
ties from the brackets on the Right Handrail (90)
and Left Handrail (not shown). Press the Cage
Nuts (38) back into place if necessary.
Connect the Upright Wire (77) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON.
Then, insert the connectors into the Right
Upright (78). Remove the wire ties from the
Upright Wire (77) and the console wire.
Set the console assembly on the Right Upright
(78) and the Left Upright (not shown). Make
sure that no wires are pinched.
Console Assembly\
f
77_Console Wire
/ /_ 78
Q
3
Console /1_
Wire_
77_
0
.
Partially tighten two M8 x 25mm Bolts (6) with
two M8 Star Washers (10) into the Left Upright
(73) and the Left Handrail (89).
Next, partially tighten two M8 x 25mm Bolts (6)
with two M8 Star Washers (10) into the Right
Upright (78) and the Right Handrail (90). Then,
tighten all four Bolts.
See steps 4 and 6. Tighten the four M10 x
96mm Bolts (5).
89
78
9