ProForm XP crosswalk 580 User Manual page 13

16. Insert the end of a Crosswalk Arm (82) into the
hole in the top of a resistance assembly. Make
sure that the bend in the Crosswalk Arm is
positioned as shown.
Tighten a #8 x 3/4" Screw (1) into the resistance
assembly and Crosswalk Arm (82) from the di-
rection shown, Press a Small Cap (89) into the
hole for the Screw.
Attach the other Crosswalk Arm (82) in the
same way.
16
Assembly
17. Raise the Frame (48) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (45) so that the large
barrel and the Latch Knob (46) are in the posi-
tions shown.
Attach the upper end of the Storage Latch (45)
to the bracket on the Frame (48) with a 3/8" x 2"
Bolt (9) and a 3/8" Nut (10).
Attach the lower end of the Storage Latch (45) to
the Base (96) with a 3/8" x 1 3/4" Bolt (7), Note:
It may be necessary to move the Frame (48)
back and forth to align the Storage Latch with
the Base.
Lower the Frame (48) (see HOW TO LOWER
THE TREADMILL FOR USE on page 21).
17
Large
Barrel
96
48
7
18. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic, To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included, Keep the included hex key in a secure place; the hex key is used
to adjust the walking belt (see pages 23 and 24).
13