ProForm XP crosswalk 580 User Manual page 11

11. While a second person holds the console as-
sembly near the Pulse Bar (110), connect the
ground wire from the console assembly to the
Console Ground Wire (109) on the Pulse Bar.
Connect the console wire to the Wire Harness
(91). See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and
then try again, iF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Lay the wires inside
the bottom of the Pulse Bar (110).
11
Ground
Wire
Console
Assembly
Console
91
Wire
12. Set the console assembly on the Left and Right
Uprights (77, 92). Be careful not to pinch any
wires.
Attach the console assembly to the Pulse Bar
(110) with six #8 x 3/4" Screws (1). Start all six
Screws before firmly tightening any of them.
Note: Use the two Screws you removed in step
9.
12
Console Assembly
13. Identify the Right Handrail Cover (55), which is
marked with a sticker. Slide the Right Handrail
Cover onto the right Handrail (80).
Remove the paper backing from the tape in the
indicated location and press the Right Handrail
Cover (55) against the console assembly.
Tighten a #8 x 1/2" Screw (2) into the Right
Handrail Cover and the Right Upright (92); be
careful not to overtighten the Screw.
Attach the Left Handrail Cover (78) in the
same way.
13
Console
Assembl
Ta
80
11