ProForm 545 S User Manual page 8

7. Attach the T-handle (10) to the Updght (3) with two
M6 x t6mm Button Screws (54) and two M6 Nylon
Locknuts (55).
8. Make sure that there are four Pedal Arm Bushings
(11) in each Pedal Arm (12).
Identify the Left Pedal (31), which has an "L" molded
into its bottom surface. Attach the Left Pedal to one of
the Pedal Arms (12) using three M4 x 19mm Flange
Screws (9).
Attach the Right Pedal (not shown) in the same way.
9. Apply a thin film of grease to the left Handlebar (8)
and the Crank Arm (59) in the Indicated Iocat=_ons.
Slide a Nylon Spacer (39) onto the Handlebar (8) and
a Pedal Arm Spacer (41) onto the Crank Arm (59).
Next, slide the Pedal Arm (12) with the Left Pedal
(31) onto the Handlebar and the Crank Arm. Secure
the Pedal Arm by tapping one 3/4" Axle Cap (43) onto
the Handlebar and another one onto the Crank Arm.
Attach the other Pedal Arm (not shown) to the right
side of the elliptical in the same way.
10. The Console (6) requires two =AA"battedes (not
included). Alkaline battedes are recommended.
To install battedes, first locate the battery clip under
the Console (6). Insert two battedes into the battery
clip as shown, Make sure that the batteries are
tumed so the negative ends of the batteries
(marked =-') are touching the springs in the
battery clip.
8
7
O 63
11
12
9
Greas
Grease
59
43 31
41
10 @ I_
Ba.e __ _
Cl,p-- L_J
I I
_6
7Battedes
11. Make sure that all parts of the elliptical are propady tightened. Place a mat under the elliptical to protect
the floor or carpet from damage.
8