Installation Instructions - Envision EN7600 Owner's Manual

INSTALLATION INSTRUCTIONS

SWIVEL BASE
Install
Figure 1
POWER CORD
Power Source:
1. Make sure that the power cord is the correct type required in your area.
2. This LCD monitor has an External universal power supply that allows
operation in either 100/120V AC or 220/240V AC voltage area (No user
adjustment is required.)
3. Connect the power cord into your LCD monitor's power input socket, and
then plug the other end into a 3-pin AC power outlet. The power cord may
be connected to either a wall power outlet or the power outlet socket on
your PC, depending on the type of power cord supplied with your LCD
monitor.
NOTES
A certified power supply cord has to be used with this equipment. The
relevant national installation and/or equipment regulations shall be
considered. A certified power supply cord not lighter than ordinary polyvinyl
chloride flexible cord according to IEC 60227 (designation H05VV-F 3G
2
0.75mm or H05VVH2-F2 3G 0.75mm
cord be of synthetic rubber according to IEC 60245 (designation H05RR-F
2
3G 0.75mm ) shall be used.
Installing and Removing the Swivel Base
2
) shall be used. Alternative a flexible
5
Remove