Dynamic Routing - NetComm NB3300 Quick Start Manual

Application Name Enter the name of the application you wish to configure in the
Application Name column to identify this setting. This is just a label and does not govern
the function of the settings.
Outgoing Port Range Enter the port number or range of numbers this application uses
when it sends packets outbound. The Outgoing Control port numbers act as the trigger.
When the NetComm ADSL Modem Router detects the outgoing packets with these port
numbers, it will allow the inbound packets with the Incoming Port Numbers that you set in
the next column to pass through the NetComm ADSL Modem Router.
Incoming Control Enter the port number or range of numbers the inbound packets carry.
Click "Apply" after making any changes.
Followings are port numbers list of some popular application:
Application
Battle.net
DialPad
ICQ
ICU II
IRC
MSN Gaming Zone
PC to Phone
Quick Time4
wowcall

4-5 Dynamic Routing

The Dynamic Routing feature allows your NetComm ADSL Modem Router to exchange routing
information with other routers in the network. Enabling this feature is likely to enhance
performance of your NetComm ADSL Modem Router.
TX From the drop-down list, select one of the routing information types, "RIP-1", "RIP-1
Compatible", or "RIP-2", to enable the "TX" (transmit) function. "RIP-1" is the protocol
used by older routers and newer routers should use "RIP-2". "RIP-1 Compatible" serves to
broadcast RIP-1 and multicast RIP-2.
RX From the drop-down list, select one of the routing information types, "RIP-1" or "RIP-
2", to enable the "RX" (receive) function.
Click "Apply" after making any changes.
www.netcomm.com.au
Page 30
Outgoing Control
6112
7175
4000
2019
6667
47624
12053
554
8000
Incoming Data
6112
51200, 51201,51210
4000
2000-2038, 2050-2051, 2069,
2085,3010-3030
531, 6666, 6667
2300-2400, 28800-29000
12120,12122, 24150-24220
6970-6999
4000-4020
ADSL Modem Router
Rev.1 - YML632