Step Recording; Style Assembly - Yamaha Tyros4 Reference Manual

Step Recording

In the EDIT Page, you can record notes with absolutely precise timing. This Step Recording procedure is essentially the
same as that for Song Recording
• In the Song Creator, the End Mark position can be changed freely; in the Style Creator, it cannot be changed. This is
because the length of the Style is automatically fixed, depending on the selected section. For example, if you create a
Style based on a section of four measures length, the End Mark position is automatically set to the end of the fourth
measure, and cannot be changed in the Step Recording display.
• Recording channels can be changed in the Song Creator 1-16 tab display; however, they cannot be changed in the Style
Creator. Select the recording channel in the BASIC tab display.
• In the Style Creator, the channel data can be entered and System Exclusive data can be edited (delete, copy, or move).
You can switch between the two by pressing the [F] button. However, Chord, Lyrics, and System Exclusive data cannot
be entered.
For instructions on Step Recording, refer to
to page 73.

Style Assembly

Style Assembly allows you to create a single Style by mixing the various patterns (channels) from existing internal
Styles.
1
Select the desired Style to serve as the basis for recording/edit-
ing before calling up the Style Creator display.
2
Call up the operation display.
[DIGITAL RECORDING]  [B] STYLE CREATOR  TAB [][] ASSEM-
BLY
3
Select the desired section (Intro, Main, Ending, etc.) for your
new Style.
First call up the SECTION Selection display by pressing one of the Section but-
tons (INTRO, MAIN, ENDING, etc.) on the panel. Then change the section as
desired by using the [6 ]/[7 ] buttons and actually enter the selection by
pressing the [8 ] (OK) button.
NEXT PAGE
44
Tyros4 Reference Manual
(page 61) with the exception of the points listed below:
pages 61–64. For information on the EDIT display (Event List display), refer
NOTE
You cannot select INTRO 4 and ENDING
4 sections directly via the panel opera-
tion.